GameSir G7 SE Motherboard Replacement

Einleitung

The GameSir G7 SE motherboard replacement guide is intended for users facing complex operational issues stemming from the device's central circuit board. Such problems could range from power issues to unresponsive controls.

Prior to beginning this repair, disconnect the controller from all power sources and prepare ESD-safe tools to prevent damage to electronic components. Due to the complexity of this task, it’s important to follow each step meticulously to avoid further issues.

Was du brauchst

Schritt 1 Interior face plate

GameSir G7 SE Motherboard Replacement, Interior face plate: Schritt 1, Bild 1 von 1

Remove the faceplate by prying upwards with a plastic opening tool.
This faceplate is magnetic and will be easy to come off.

Übersetzen

Schritt 2

Use a T6 Torx Screwdriver to remove the six 9 mm screws from the interior face plate.

Übersetzen

Schritt 3

Using a plastic spudger tool, remove the interior face plate. Go around all the edges, prying downwards until it's removed.
Make sure to hold the controller upside down; otherwise the buttons will fall out.

Übersetzen

Schritt 4 Motherboard

GameSir G7 SE Motherboard Replacement, Motherboard: Schritt 4, Bild 1 von 1

Use the Phillips #0 screwdriver bit to remove the four 9 mm screws holding the motherboard in place.

Übersetzen

Schritt 5

Pull straight up on the board to remove the motherboard and connecting components
Be careful to not dislodge the back buttons from the back plate housing

Übersetzen